ASTM F1978

ASTM F1089

Corrosion of surgical instruments

ASTM F1801

Corrosion fatigue testing of metallic implant materials

ASTM F1875

Fretting corrosion testing of modular implants – Femoral stem-head interface

ASTM F2129

Corrosion test of small implants

ASTM F3044

Galvanic corrosion

ASTM F897

Fretting corrosion of osteosynthesis plates and screws

ASTM G102

Calculation of corrosion rates

ISO 13402

Surgical and dental hand instruments – Determination of resistance against autoclaving, corrosion and thermal exposure

ISO 16429

Assessment of corrosion behaviour of metallic implantable materials

Abrasion resistance of coatings

Normative References

ASTM F1978: Standard Test Method for Measuring Abrasion Resistance of Metallic Thermal Spray Coatings by Using the Taber Abraser.

This test method quantifies the abrasion resistance of metallic coatings produced by thermal spray processes on flat metallic surfaces. It is intended as a means of characterizing coatings used on surgical implants. It uses the Taber® Abraser, which generates a combination of rolling and rubbing to cause wear to the coating surface. Wear is quantified as cumulative mass loss. A typical test runs up to 100 cycles at 6 samples.

Due to the flexibility of the test set-up other materials such as decking, coatings and films can be investigated.  

Contact Person male

Your contact person

Dipl. Ing. Christian Findeiss

Head of Fatigue Testing & Material Analysis, Head of Vascular Testing